Instructions / Assembly

Assembly - Bar Top (Cont.)

Install one support brace (MM) to both sides of one bar top support (JJ) and front panel side adapter (CC) using

one bolt (ZZ) and one nut (XX). Leave the bolt and nut loose at this time allowing the support braces (MM) to hang freely.

Secure the bottoms of the support braces (MM) to the front panel side adapter (CC) using two screws (TT). After the

screws are secured to the front panel side adapter, tighten the previously installed bolt (ZZ) and nut (XX) securely.

Repeat the process for the remaining two bar top supports (JJ) to the front panel side adapters (CC).

ZZ x2

TT x2

7/16”

(XX) x3(ZZ) x3

(TT) x6

Using three screws each (TT), secure the bar top (P)

to each of the four angle support (LL).

x12

(TT) x12