Instructions / Assembly

11
Using the included 4mm Hex Key, insert threaded nuts (SS) into right
side panel (C), left side panel (B), right divider (L), left divider (K) and
small drawer boxes (S).
Refer to panel threaded nut locations shown below.
NOTE: Some pressure is required to start the threaded nuts (SS)
into the plastic panels. Tighten until flush with the panel surface.
Do not overtighten.
S CB
SS
LK
x30
S CB
SS
LK
x30
1
Pre-Assembly - Drawers
This product uses self-tapping screws in some areas. There are no pre-drilled holes. Use force when
starting to drive the screw. Once the screw pierces the plastic it will drive easier.
(SS) x30