Installation Guide

Assembly - Sand Containers
Assembly - Cabinet Floor
IMPORTANT: Do not use this product without the sand containers filled and properly placed in the base.
NOTE: Be sure the product is located in the desired location for use prior to inserting the sand containers ( V) into the base.
Place filled sand containers ( V) into the base as shown. The sand containers should be positioned against the front
panels ( D, E, F).
el%
geJ
%It
El
With the drawer glides ( Y) facing up, slide the cabinet floor ( J) into position over the toe kicks ( G, H, I) and
against the front panels ( D, E, F). Lower the rear edge of the cabinet floor ( J) until it locks into the side
panels ( B, C).
CAUTION: Be careful of the installed drawer glides ( Y) while moving the cabinet floor ( J).
hmi
27