Installation Guide

Pre- Assembly - Drawers
This product uses self- tapping screws in some areas. There are no pre- drilled holes. Use force when
starting to drive the screw. Once the screw pierces the plastic it will drive easier.
cl
Using the included 4mm Hex Key, insert screw insert ( SS) into right
side panel ( C), left side panel ( B), right divider ( L), left divider ( K) and
small drawer boxes ( S).
Refer to panel threaded nut locations shown below.
NOTE: Some pressure is required to start the screw insert ( SS)
into the plastic panels. Tighten until flush with the panel surface.
Do not overtighten.
(SS) x30
is
MN
g "
M's
1 [01
•
•7,
à
•7.
[01
à
s al
e
11