Product Manual

BRISBANE
11-15 Oasis Court, Clontarf, QLD 4019
Phone : [phone] Fax : [phone]
E-mail : [e-mail]
www.aussietraveller.com.au
MELBOURNE
235A Barry Road, Campbellfield VIC 3061
Ph: 03 9357 6565 Fx: 03 9357 6515
E-mail: [e-mail]
I00109A2\9
Step 6.
To raise awning:
a) Swing trigger handle on Side of arm upward.
b) Lift handle slightly and pull
and hold trigger with index
finger.
c) Using handle lift awning half
way up. Release trigger and
let arm slide down slowly
until trigger locks.
d) Repeat other arm lifting
awning all the way up.
e) Go back to the first arm and
lift all the way up.
Figure 6
NOTE: In light rain conditions, lower one arm 300mm-
600mm to allow water to drain from fabric to avoid water
pooling. Not required if using Anti Flap Kits & Curved Roof
Rafter’s.
Step 7.
Curved Roof Rafter
a) Fit hook end into the bracket underneath the awning
track.
b) Extend rafter out and slot the spigot end into the hole
in the roller tube.
c) Tighten the black locking knob.
RECOMMENDATION: The All Terrain position (support arms
remain attached to R.V.) is stronger and more stable than
Patio position and should be preferred when using the
awning.
2. TO MOVE FRAMESET LEGS FROM ALL
TERRAIN POSITION TO PATIO
POSITION
Ensure that the Anti-Flap Kit and Curved Roof Rafters
have been removed before attempting to move the
frameset legs into the patio position.
NOT RECOMMENDED:
NOTE: FOR POP TOP CARAVANS
Because the awning rafter arm fits to the shoulder of the pop
top caravan and not level with the fabric on the pop top,
moving the arm from the All Terrain position to Patio
position and back to All Terrain position must be executed
correctly. If not executed correctly the action has the
potential to damage both the ratchet mechanism and the
top frameset mounting bracket on the pop-top shoulder.
Figure 7
Step 1.
Set up awning according to instructions for Rollout
Procedure A.
Step 2.
Ensure rafter knobs shown in Figure 5 are very tight.
IMPORTANT: With awning roller parallel to ground move
ratchet lever to down (roll out) position.
Step 3.
Depress latch on bottom bracket. Using lift handle swing arm
away from R.V. until set in vertical position. (Do not pull
trigger during this step.)
Step 4.
Adjust roller to desired height using trigger handle and
trigger.
Step 5.
Secure bottom foot to ground by
driving stakes (not provided) in
crisscross manner (See Figure 8).
Repeat other arm. Take care not to
break foot casting.
Figure 8
NOTE: Additional tie down straps are recommended. We
have off the shelf products for this purpose; see Caravan
Awning Rope Clips 05000020001000, also Tie Down Straps
36000010001080.s
Step 6.
When erected ensure the roller pull strap sail track is
positioned at 9 o’clock (left end) as per drawing below. This
will allow rain water to run off the fabric by minimising
pooling behind the roller.
Reposition the roller as follows:
a) Loosen black rafter knobs.
b) Pull down and away from the vehicle to release
pressure from the ratchet and move ratchet lever
to the roll up position.
c) Release the pressure on the pull strap and allow
the roller to roll up until just past the 9 o’clock
position. (See Figure 9)