Installation Manual

Step 4: Attach the Mount Head

Screw the mount head on to the end of the extension pole and tighten

set screw (Fig 4).

Step 5: Attach the Adapter Plate to the Display

Attach the adapter plate to the display using M4, M5, M6, or M8

screws. For displays with a hole pattern in a pocket or inputs behind

adapter plate, spacers go between adapter plate and display (Fig 5).

Step 6: Attach the Adapter Plate with Display to Ceiling Mount

Assembly

a. Attach adapter plate and display onto wall arm assembly, ensuring

all 3 hooks slide into holes of mount head (Fig 6).

b. Using a Philip’s screwdriver, tighten down locking screw located on

adapter plate into threaded hole in the mount head.

ADJUSTMENTS

Tilt Adjustment

a. Loosen screws on side of mount head (only enough to allow

controlled adjustment) (Fig 7).

b. Adjust tilt forward or backward.

c. Retighten screws, then check to ensure that tilt angle is locked in

place.

Fig 4

171016-1614

LIFETIME LIMITED WARRANTY

SunbriteTV™ Mounts have a Lifetime Limited Warranty. This warranty includes parts and labor repairs on all

components found to be defective in material or workmanship under normal conditions of use. This warranty shall

not apply to products which have been abused, modified or disassembled. Products to be repaired under this

warranty must be returned to SunbriteTV or a designated service center with prior notification and an assigned return

authorization (RA) number.

Technical Support 866.838.5052

Fig 5

Fig 6

Fig 7