Operator's Manual

Step 4: Attach the Mount Head
a. Inserting through-bolts on adapter plate through angled slots in
mounting head. Place M8 washers and nylock nuts on end of
through bolts and tighten down (Fig 4).
b. Screw mount head on to end of extension pole and tighten set
screws (Fig 5).
Step 5: Attach the TV Arms to the Display
Attach the TV arms to the display using M4, M5, M6, or M8 screws.
For displays with a hole pattern in a pocket or inputs behind adapter
plate, spacers go between TV arms and display (Fig 6).
Step 6: Attach the Display to the Ceiling Mount Assembly
a. Lift the display and hang it on the wall arm assembly by the TV
arms, ensuring all 3 hooks slide into holes of mount head (Fig 7).
b. Using a Philip’s screwdriver, tighten down locking screws at the
bottom of each TV arm,ensuring that the screws hold the arms
captive to the bracket (Fig 8).
c. Insert locking pin (Fig 9).
ADJUSTMENTS
Tilt Adjustment
a. Loosen screws on side of mount head (only enough to allow
controlled adjustment).
b. Adjust tilt forward or backward.
c. Retighten screws, then check to ensure that tilt angle is locked in
place.
Horizontal Adjustment (Roll)
a. Slightly loosen all 4 nylock nuts behind adapter plate only to allow
movement of the plate.
b. Using the corners of the TV, adjust left/right until level. Re-tighten
all nylock nuts.
WARNING: Completely loosening and/or removing nuts may
cause plate and/or TV to fall causing serious injury.
Fig 4 Fig 5
171016-1608
LIFETIME LIMITED WARRANTY
SunbriteTV™ Mounts have a Lifetime Limited Warranty. This warranty includes parts and labor repairs on all
components found to be defective in material or workmanship under normal conditions of use. This warranty shall
not apply to products which have been abused, modified or disassembled. Products to be repaired under this
warranty must be returned to SunbriteTV or a designated service center with prior notification and an assigned return
authorization (RA) number.
Technical Support 866.838.5052
Fig 8 Fig 9
Fig 6
Fig 7