Operating Guide

Step 3: Hang TV on to the Wall Plate

A. Carefully lift the TV to hook the arms over the

top lip of the wall plate. Allow the lower portion of the

arms to swivel in under the bottom lip of the wall plate.

Do not release the TV until it is completely connected to the

wall plate (Figure 5).

ADJUSTMENTS:

Adjust Horizontal Level and Tilt

Forward Tilt Adjustment (SB-WM-T-L-BL)

A. Using the included long Allen key, loosen the tilt adjustment

locks on the sides of the arms enough to allow movement.

B. Set the tilt to the desired angle, then re-tighten the locks. If

the locks cannot be tightened enough, remove the TV from

the wall for better access.

Horizontal Adjustment

A. If display is not horizontally level when mounted, Tilt

Adjustment Screws are included at the top of each arm

for micro-adjustments (Figure 7). Use provided Allen Key to

raise or lower the screw, which will in turn raise or lower the

mount.

Note: Due to display weight, it may be easier to lift panel

slightly when adjusting the screw. Caution should be taken

to avoid any slips or drops to avoid damage and/or injuries.

Locking

A. To lock the arms to the wall bracket, twist the locking tabs

until the edge catches behind the bracket. The Allen Key

can be used as a tool to help with this step. Padlock is

optional (not included).

±5° Horizontal

Adjustment

Tilt Adjustment

Screw

Locking

Tab

Tilt Adjustment Lock

Figure 5

Figure 6

Figure 7

Lifetime Limited Warranty

SunbriteTV™ Mounts have a Lifetime Limited Warranty. This warranty includes parts and labor repairs on all compo-

nents found to be defective in material or workmanship under normal conditions of use. This warranty shall not apply

to products which have been abused, modied or disassembled. Products to be repaired under this warranty must be

returned to SunbriteTV or a designated service center with prior notication and an assigned return authorization (RA)

number.

Technical Support 866.838.5052