Manual
Step 3: Hang TV on to the Wall Plate
a. Carefully lift the TV to hook the arms over the
top lip of the wall plate. Allow the lower portion of the
arms to swivel in under the bottom lip of the wall plate.
Do not release the TV until it is completely
connected to the wall plate.
Adjustments:
Adjust Horizontal Level and Tilt
Forward Tilt Adjustment (SB-WM-T-L-BL)
a. Using the included long Allen key, loosen the tilt adjustment
locks on the sides of the arms enough to allow movement.
b. Set the tilt to the desired angle, then re-tighten the locks. If
the locks cannot be tightened enough, remove the TV from
the wall for better access.
Horizontal Adjustment
a. If display is not horizontally level when mounted, Tilt
Adjustment Screws are included at the top of each arm
for micro-adjustments (Figure 7). Use provided
Allen Key to raise or lower the screw, which will in
turn raise or lower the mount.
Note: Due to display weight, it may be easier to lift panel
slightly when adjusting the screw. Caution should be taken
to avoid any slips or drops to avoid damage and/or injuries.
Locking
a. To lock the arms to the wall bracket, twist the locking tabs
until the edge catches behind the bracket. The Allen Key
can be used as a tool to help with this step. Padlock is
optional (not included).
Tilt Adjustment Lock
±5° Horizontal
Adjustment
Tilt Adjustment
Screw
Locking
Tab
Figure 5
Figure 6
Figure 7
Lifetime Limited Warranty
SunbriteTV™ Mounts have a Lifetime Limited Warranty. This warranty includes parts and labor repairs on all com-
ponents found to be defective in material or workmanship under normal conditions of use. This warranty shall
not apply to products which have been abused, modied or disassembled. Products to be repaired under this
warranty must be returned to SunbriteTV or a designated service center with prior notication and an assigned
return authorization (RA) number.
Technical Support 866.838.5052
170315-0816