Installation Guide
5
Wall Mounting of Arm Assembly
Hammer concrete anchors (V) into wall as applicable.
Warning: If anchors are going to be applied to a plastered concrete wall, the anchor must be
recessed beyond the plaster to reside fully in the concrete.
Apply washers (Z) to lag bolts (X).
Place Arm Assembly in position. Thread lag bolts with washers (X+Z) through the Arm Assembly into
pilot joles / wall anchors.
Pro Tip: Orient the Arm Assembly so that its Keyed Notches side of the Head Mount are up.
Tighten bolts (X) snugly without overtightening.
Caution: Overtightening can damage the bolts and reduce their holding strength.
Masonry Anchors
(Y)
(for concrete only)
Head
Mount
1/4" Holes for Studs
5/16" Holes for Concrete
Keyed
Notches
Washers (Z)
Lag Bolts (X)
Arm Assembly