Installation Guide

4
Installation
Layout and Drilling
Determine general location of the display. Use a level to tape the template flat and level on the wall.
For wood walls, use a stud finder to find the nearest wall studs. Mark their location, and align the
template’s slots with the centers of the stud markings.
Pro Tip: Fold the template corners up to catch debris as you drill.
Caution: Before drilling, verify the concrete is at least 1-3/8” thick. Ensure to mount in a solid part
of the block, 1” minimum from the side of the block. Do not drill into mortar joints.
Caution: Concrete must be 2000 psi density minimum. Lighter density concrete may not hold
concrete anchor. Cinder block must meet ASTM C-90 specifications.
Caution: Use a standard electric drill on slow setting. Do not use a hammer drill to avoid breaking
out the back of the hole when entering a void or cavity.
Mark the bore locations. Drill holes in marked locations:
Use 1/4" bit for drilling into wooden studs.
Use 5/16" bit for drilling into concrete wall.