Installation Guide

2
The maximum weight of this wall mount is 150 lbs (68 kg). Use with heavier than the maximum weight
indicated may result in instability causing possible injury.
Ensure these instructions are thoroughly understood before attempting installation. If unsure of any
part of the installation process, contact a professional installer for assistance.
The wall or mounting surface must be capable of supporting the combined weight of the mount and
the display; otherwise the structure must be reinforced. Installer is responsible for verifying the wall/
mounting surface and the anchors used can support the total load of the installation.
Safety gear and proper tools must be used. Failure to do so can result in property damage and/or
serious injury.
A minimum of two people is required for this installation and it is highly recommended that this
product be installed by qualified professionals.
Follow all instructions and recommendations regarding suitable locations for display installation.
Consult the display equipment’s documentation for information relative to its requirements.
NOTE: This mount supports display mounting from VESA 200×100 up to 600×400.
Specifications Box Contents Tools Required
Maximum Load: 90 lbs (41 kg) Wall Arm Assembly (1) Power Drill
Maximum Extension: 24-3/8" Adapter Brackets (2) 1/4" & 5/16" Drill Bits
Wire Management Adapter Plate (1) Level
Pan/Swivel Range: 180° SunBrite Adapter Bars (4) 1/2" (13mm) Wrench
Tilt Range: -5° / +15° Cable Covers (2) Hammer
Dacromet Coated Assembly Hardware Kit (1) Stud Finder
Mounting Hardware Template (1) Phillips Screw Driver