Use and Care Manual
Use and Care
Use: For ironing and steaming clothes and draperies
Care: Clean soleplate after every 30 uses, or more frequently if starch is used or build-up starts to
accumulate. Before cleaning, ensure iron is unplugged and cool.
WARNING: To avoid the risk of electric shock, do not immerse the iron in water or other liquids.
Note: Do not use abrasive cleansers, scouring pads or vinegar to clean the soleplate. This will damage
the finish.
Type of Debris/Build-Up Cleaning Recommendation
Light Dirt Use a cotton cloth or terrycloth towel to wipe the
soleplate with warm soapy water.
Hard Water Deposits Use a cotton cloth or terrycloth towel to wipe the
soleplate with a 50/50 vinegar/water mixture.
Heavy Starch or Residue Build-up Use Hot Iron Cleaner or Mr. Clean® Magic Eraser®
cleaning pad. Refer to the manufacturer’s directions
included with these products for specific cleaner usage
instructions.
Mr. Clean® and Magic Eraser® are registered
trademarks owned by the Procter & Gamble company.
ANTI-CALCIUM SYSTEM
Anti-calcium is a permanent system located inside the water reservoir to eliminate impurities.
TO PROLONG EFFICIENCY, FOLLOW THESE STEPS ONCE A MONTH OR AFTER EVERY 30 USES:
1. Turn off iron.
2. Add 1 teaspoon of salt to ¾ cup water and fill water reservoir with this solution.
3. Leave solution in water reservoir for 15 minutes, shake occasionally, and then empty through the
water fill hole or through the “self-clean method”.
4. Fill water reservoir again with salt water solution, shake and empty after 15 minutes.
5. Fill water reservoir with fresh water to rinse and empty.
-