Cookware User Manual

9
Before the first use: Wash, rinse and dry your
frypan and lid. ‘Season’ the cooking surface
by applying a thin coat of cooking oil and rub
in with paper towelling.
Note: When using your Ellise Stainless
Cookware for the first time you may notice a
fine smoke haze being emitted from the unit.
This is normal. It is due to the initial heating
of internal components.
1. Insert the control probe into the inlet on
the frypan.
2. Plug the cord into a 230-240V power
outlet and turn the power on.
3. Preheat the frypan on setting 7-8, then
set the control probe dial to the desired
temperature setting. Refer to page 7 for
the temperature guide.
The light on the control probe will illuminate.
This light will remain on until the set
temperature has been reached and then will
cycle on and off throughout cooking, as the
cooking temperature is maintained by the
thermostat.
Hint: On initial heating of the frypan, it
is recommended that the temperature be
allowed to cycle (the light glowing on and
off) several times. This will help the cooking
surface to adjust to a more accurate cooking
temperature.
Note: The frypan must only be used with the
control probe provided.
Using your Cookware
Always turn the power off and remove the
plug from the power outlet after use and
before cleaning. Allow appliance to cool
before cleaning.
Control Probe
If cleaning is necessary, wipe over with a
damp cloth.
Note: The control probe must be removed
before the frypan is cleaned and the control
probe inlet must be dried before the frypan is
used again.
IMPORTANT: DO NOT IMMERSE THE CONTROL
PROBE IN WATER OR OTHER LIQUID.
Store the control probe carefully. Do not
knock or drop it as this can damage the
probe. If damage is suspected, return the
control probe to your nearest Sunbeam
Appointed Service Centre for inspection.
Refer to the separate warranty and service
centre booklet.
Glass lid
Wash the lid in warm soapy water using a
soft sponge, rinse and dry thoroughly. The
glass lid is dishwasher safe.
Note: Take care when glass lid is hot. Do not
place hot lid under water or on cold surfaces.
This may cause lid to crack.
Care and Cleaning
9