User's Manual

4
Note: The heat pad is designed to fit within
the edges of your mattress (see Figure 1).
This ensures the best, smoothest and firm
fit of your blanket to the mattress. As the
blanket settles in to the fit of the bed, any fold
ridges should smooth out over time.
Place the electric blanket on your mattress
with the control sockets on the underside
of the blanket near the head of the bed
(see Figure 1). Ensure the heating wires
do not extend under the pillows.
A single or king single electric blanket
can be turned over so that the control is
on the preferred side of the bed if desired.
Please note that this may result in the control
facing towards the bed once the bed is made.
Pull the fitted skirt over the top corners of
the mattress. To fit the foot of the bed, pull
from the centre of the blanket to the foot of
the bed, and fit one corner at a time while
holding the centre (see Figure 2).
Ensure the fitted skirt is completely under
the mattress. Pull on the edges of the
blanket to ensure that it is flat and square
on the mattress.
Fitting your electric blanket
Figure 1.
Figure 2.