User's Manual

ReaDy to Use
Note:TheBATTERYINSTALLATIONandCOLLARFITTINGstepsmustbe
completedbeforeyouarereadytouse.
STEP 1:HoldingthemainbodyoftheSunbeam®ReceiverCollarinbothhands
PRESSandHOLDtheControlButtonfor4seconds.
Note:Youwillhearonelongbeepfollowedbyasequenceofshortbeepsand
ashing green LED indicating which correction level is in use. The Receiver
Collarwillrecallthelastsettingorthedefaultsetting(level1orlow).
STEP 2:Setcorrectionlevelbypressingandholding(approximately2seconds)
the Control Button.
Once the collar is ON press the Control Button once to toggle to the next correction level.
Note:ItisrecommendedtostartontheLOWsettingandmonitoryourdog’sbehaviorbeforedetermining
ifahighercorrectionlevelisneeded.
Thebelowtabledescribesthecorrectionlevelsettings.
STEP 3:AttachcollartoyourdogasyoudidintheCOLLARFITTINGstage.
sPecIal oPeRatInG notes
TheSunbeam®ReceiverCollarretainstheLASTcorrectionlevelsettingandwillresumethismodewhentheunit
is turned on.
LowBatteryMode:TheReceiverCollarLEDwillashREDfor5secondswhenthebatteryneedstobereplaced.
ReminderCorrection:WhenyourdogreachestheBoundaryZonetheywillreceiveaStaticCorrection.Ifyour
dogisstillintheBoundaryZonewhentheStaticCorrectionreachesthemaximumlimit,theReceiverCollarwill
administrate a Reminder Correction. The Reminder Correction is a very low Static Correction intended to remind
thedogtoleavetheBoundaryZone.
MultipleDogs:Ifyouhavemultipledogsadditionalcollarscanbeaddedtoyoursystem.Contacttheretailer
fromwhichyoupurchasedtheIn-GroundFencingSystemorcall866-537-2249.
19
FlashingRed:Lowbattery
Level Beeps GreenLEDLight
1-low 1shortbeep 1ash(repeated6times)
2-medium 2shortbeeps 2ashes(repeated6times)
3-high 3shortbeeps 3ashes(repeated6times)
correction level settings