User's Manual

settInG UP tHe boUnDaRy flaGs
• YoumustsetuptheBoundaryFlagsasavisualaidforyourdog.The
BoundaryFlagswillremindyourdogwheretheBoundaryZoneislocated.
• UsingtheReceiverCollarandTestLightasaguide,beginplacingyour
Boundary Flags at the point where you hear the Warning Tone. Space the
BoundaryFlagsaboutonetotwoyardsapartinsmallyardsandabouttento
fteenfeetapartinlargeyards.
• IfthereareareasoftheBoundaryZonewhereyoucannotplanttheags
intothegroundllasmallcanwithsand,placethelledcanontheedgeof
theBoundaryZoneandplacetheaginthesand.Repeatthisprocessuntil
youhavemarkedtheentireBoundaryZonewithBoundaryFlags.
ReceIveR collaR oPeRatInG InstRUctIons
batteRy InstallatIon
IMPORTANT: This step is to be completed when the collar is NOT on your dog.
•Removetwoscrewssecuringthebatterycompartmentusingacrosshead
orPhillipsheadscrewdriver.(g.24)
•LiftbatterycompartmentfrommainbodyofReceiverCollar.(g.25)
•InserttwoCR2032Lithiumcoinbatteriesintobatterycompartment.
Batteriesshouldbeplacedwiththepositivesidefacingdown.
IMPORTANT: Follow orientation as described on graphics illustrated
on battery compartment. (g. 26)
•ReplacebatterycompartmentwithtwoCR2032Lithiumcoinbatteriesback
intomainbody.Note:Thebatterycompartmentcanonlybeassembledin
oneorientation,donotforceclosed.Seemarkingsonthebatterydoor.
•Tightenthetwoscrewsusingthecross-headscrewdriver,donotovertighten.
•Totesttheunitturnonbypressingandholdingthecontrolbuttonfor
4seconds.Youwillhearonelongbeepfollowedbyasequenceofshort
beepsandashinggreenLEDindicatingwhichcorrectionlevelisinuse.
TheReceiverCollarwillrecallthelastsettingorthedefaultsetting
(level1orlow).
•Toturnotheunit,pressandholdthecontrolbuttonfor4seconds.Youwill
hearshortbeepsindicatingthecurrentcorrectionlevelfollowedbyalong
beepindicatingtheunitiso.
•BeforereplacingbatteriesyoumustcompletelydischargetheReceiver
Collar. Be sure the unit is in the OFF position and place the metal portion
ofaplastichandlescrewdriveracrossbothstainlesssteelprobesfor
5seconds.Disposeofbatteriesperlocal,stateandnationallaws
and regulations.
17
gure 24
gure 25
gure 26