User's Manual

15
connectInG & testInG tHe systeM
• UsearulertomeasurethedistancebetweenthemountingholesonthesidesofyourBaseTransmitter.TheBase
Transmittermustmounttoastationarysurface.
• UsingthemountingholesonyourBaseTransmitterasamountingtemplate,
use a level and a ruler to mark on your wall where the screws will go.
• UsingaPhilipsheadscrewdrivermounttheBaseTransmitterdirectlyinto
thewall.Ifyouarenotmountingdirectlyintothewallstud,installthescrew
anchorssuppliedbeforeattachingthetransmittertothewall.
• TheBoundaryWiremustruntotheoutsidewhereyouwilllayoutyoursystem.
MakesurethattheBoundaryWireisnotbeingpinchedbyanydoorsorwindows
asthiswilldamagethewire.Ifnecessary,youmayhavetodrillaholethrough
the wall.
• NOTE:EnsurethatthebaseTransmitterisunpluggedbeforeinsertingthe
Boundary Wires into the Base Transmitter.
• InsertoneendoftheBoundaryWireintotheblacktabonthebottomofthe
BaseTransmitterbypullingbacktheblacktab.(g.18)
• InserttheotherendoftheBoundaryWireintotheredtabonthebottom
oftheBaseTransmitterbypullingbacktheredtab.(g.19)
• InserttheACadaptorintotheBaseTransmitterandplugtheACadaptor
into a power outlet.
•TurnontheBaseTransmitterbyturningtheBoundaryZoneknobtotheright.
YouwillseethegreenLEDpowerindicatorlightupwhenthesystemhasbeen
turnedon.(g.20)
• Forthepurposeoftesting,turntheBoundaryZoneknoballthewaytoMAX.
• Inordertomakesurethesystemisworkingproperlyyoumusttestthewire
usingtheReceiverCollar.TurnontheReceiverCollarbypressingandholding
for4secondsuntiltheLEDindicatorlightsup.
• PlacetheTestLightholesdirectlyontotheReceiverCollarprobes.(g.21)
• SlowlybringtheReceiverCollarneartheBoundaryWireatyourpet’snecklevelwithprobesfacingup(g.22).Ifthe
system is working correctly you will hear a Warning Tone. Continue toward the Boundary Wire until you see the Test
Lightash(g.23).IfyoudonotheartheWarningToneorseetheashyoushouldreviewthepreviousdirections.
gure 20
gure 18
gure 19
gure 21 gure 22 gure 23