User's Manual

13
HoW to sPlIce WIRe
IfyouareusingTwistedWireoradditionalBoundaryWiretoexpandyourmainloop,
you will need to splice the wires together. Mark on your plan layout where your wire
splicesarelocatedforfuturereference.Yoursystemshouldnotbe
energizedwhensplicingthewires.
• Usingawirestripper,stripaboutonehalfinchofthecoatingfromthetipsof
theBoundaryWiretoexposeclean,non-corrodedBoundaryWire.
•Holdthewirestogether.Insertthewiresintothesuppliedwirenutensuringthat
thereisnocopperexposedbeyondtheendofthewirenut.Twistthewirestogether
in a clockwise direction. Pull lightly on the wire nut to make sure it is secure.
•Tieaknot4inchesfromthewirenut.
• Openthetopofthegreasetubeandinsertthewirenut.Closethecapon
thegreasetube.Thiswillwaterproofyourwiresplice.
testInG tHe systeM cont.
In order to make sure the system is working properly you must test the wire using the Receiver Collar. Install the
batteries(seepage17BatteryInstallation)andturntheReceiverCollaronbypressingandholdingfor4seconds
until the LED indicator lights up. Do not test the system while the Receiver Collar is on your dog.
• PlacetheTestLightindentationholesdirectlyontotheReceiverCollarstainlesssteelprobes.(g.13)
• SlowlybringtheReceiverCollarneartheBoundaryWireatyourpet’snecklevelwithprobesfacingup(g14).Ifthe
system is working correctly you will hear a Warning Tone. Continue toward the Boundary Wire until you see the Test
Lightash(g.15).IfyoudonotheartheWarningToneorseetheashyoushouldreviewthepreviousdirections.
• Ifyoursystemisworkingcorrectly,unplugtheBaseTransmitteranddisconnectthewiresfromtheBase
TransmitterandcontinuetofollowthedirectionsoninstallingtheBoundaryWire.
gure 13 gure 14 gure 15