User manual

To pair the transmitter and receiver again, follow the procedures in Step 2
above. If the transmitter and receiver still fail to pair after following the
procedures in step 2, remove the receiver and transmitter from the location
where they are operating, since the abnormal functioning may be due to
strong magnetic or electric interference from the environment.
2.4. Remarks:
To avoid any damage: Please do not place the whole unit in the oven.
The probe and the wire are the only parts designed to work briefly at
high temperature (below 300°C / 572 °F). For long-term (30 minutes)
use, the probe and wire must be kept below 260°C/ 500°F. The main
body of the thermometer (transmitter and receiver) must remain outside
the oven and in an environment where the temperature is
0~50°C(32~122°F).
Pair the receiver and transmitter again if there is any signal error. For
the procedure, refer to instruction of pairing process above.
To operate multiple sets of wireless thermometers, pair the transmitters
and receivers following the pairing instructions above.
The accuracy of temperature measurement refers to the difference
between this product and a regular thermometer in a constant
temperature environment.
The remote control distance may be affected by strong signal
interference, and the signal could be blocked by metal.
Replace the battery when the screen becomes dim or displays“ "icon.
The battery compartment is located at the back of the t hermometer.
Otherwise, the remote control distance may be affected. Note: Battery –
4 x AAA (2 for transmitter, 2 for receiver)
To avoid damage: Please clean the stainless steel probe with a damp
cloth before and after use. Do not immerse the unit in water or place it in
38