User manual

Step 3: Repeat step 2 with ANOTHER transmitter (Transmitter B) and
receiver (Receiver B) set (Note: Please make sure that the rest of the
transmitters and receivers are turned off). Turn on the second transmitter
(Transmitter B), then install the batteries into the second receiver
(Receiver B). The pairing process starts, and Transmitter B and Receiver B
are paired while the icon on the display of Receiver B blinks.
To ensure that the pairing process is complete, turn off (press the ON/OFF
button). Transmitter B and Receiver B will turn off automatically.
Note: Repeat steps above until all transmitters and receivers are paired
one-to-one.
Step 4: All thermometers are paired and ready for use. The transmitters
and receivers remain paired until the transmitter or receiver is out of
power. To pair the transmitter and receiver again, repeat the procedures in
step 2.
Fixing and Confirmation of pairing
Confirmation of pairing to the correct transmitter:
Turn off the transmitter: Turn off (press the ON/OFF button) the
Transmitter, and the CORRESPONDING Receiver will turn off
automatically if they are paired.
Using the timer: Run the count-up timer on the transmitter, then check
(press the mode button to shift to the timer) the value of the timer on the
receiver. The timer values on receiver and transmitter should be
ROUGHLY the same (the values may be slightly different, due to the rate of
signal transfer) if they are paired.
Fixing a pair – If the transmitter and receiver are not paired, follow the
procedures in step 2 to pair the transmitter and receiver again.
Abnormal functioning (the receiver cannot receive any signal from
the transmitter):
37