User manual

(Pairing for multiple sets of wireless thermometers)
Purpose: For multiple sets of ETC536 (in this instruction, there are 2 sets
of ETC536), to ensure that a transmitter is connected to only one ETC536
receiver (i.e. one-to-one connection) after reinstalling the batteries.
~ Pairing of first thermometer set (Set A) ~
Step 1: Turn off all transmitters by pressing the ON/OFF button (located at
top left of transmitter), and remove the batteries from ALL receivers.
Battery compartment:
Step 2: Turn on one of the transmitters (Transmitter A). Then install the
batteries back into one of the receivers (Receiver A). After full segment
display, “Receiver A” will start to receive a signal, also called pairing. The
pairing process takes about 10 seconds. Transmitter A and Receiver A are
paired while the icon on the display of Receiver A blinks.
Note: To ensure that the pairing process is complete, turn off (press the
ON/OFF button) Transmitter A, and Receiver A will turn off automatically.
~ Pairing of first thermometer set (Set A) is complete ~
36
Ming le Instr umen t GmbH Eur ope
Schm elzers tr. 30, D -47877 W illi ch
Type: E TC536
3V 0.1 5W
2x1. 5V AAA
Ming le Instr umen t GmbH Eur ope
Schm elzers tr. 30, D -47877 W illi ch
Type: E TC536
3V 0.1 5W
2x1. 5V AAA
Tim e R em a in in g