Operation Manual

58 Netra t 1400/1405 Installation and User’s Guide • September 1999
keyboard-click? false If true, enable keyboard click.
last-hardware-update no default System update information.
local-mac-address? false If true, network drivers use their
own MAC address, not the system’s.
mfg-switch? false If true, repeat system self-tests until
interrupted with a Break command.
nvramrc empty Contents of NVRAMRC.
oem-banner empty string Custom OEM banner (enabled by
oem-banner? true).
oem-banner? false If true, use custom OEM banner.
oem-logo no default Byte array custom OEM logo
(enabled by oem-logo? true).
oem logo? false If true, use custom OEM logo (else,
use Sun logo).
output device ttya Power-on output device (usually
screen, ttya,orttyb).
security-#badlogins no default Number of incorrect security
password attempts.
security-mode none Firmware security level (options:
none, command,orfull).
security-password no default Firmware security password (never
displayed). Do not set this directly.
selftest-#megs 1 Megabytes of RAM to test. Ignored if
diag-switch? is true.
testarea 0 One-byte scratch field, available for
read/write test.
ttya-mode 9600,8,n,1,– TTYA (baud rate, #bits, parity, #stop,
handshake).
ttyb-mode 9600,8,n,1,– TTYB (baud rate, #bits, parity, #stop,
handshake).
ttya-ignore-cd true If true, operating system ignores
carrier-detect on TTYA.
ttyb-ignore-cd true If true, operating system ignores
carrier-detect on TTYB.
TABLE 9-1 NVRAM Configuration Parameters (Continued)
Parameter Typical Default Description
LW3User.book Page 58 Wednesday, November 10, 1999 9:00 AM