Operation Manual

20 Netra t 1400/1405 Installation and User’s Guide • September 1999
FIGURE 3-10 Securing the Wires to the Strain Relief Housing
4. Loop the wire tie over the wires and back out of the strain relief housing, then
tighten the wire tie to secure the wires to the strain relief housing (
FIGURE 3-10).
5. Lower the three prongs on the top portion of the strain relief housing into the
openings in the DC input connector, then push the top portion and bottom
portion of the strain relief housing together until they snap into place.
LW3User.book Page 20 Wednesday, November 10, 1999 9:00 AM