Operation Manual

18 Netra t 1400/1405 Installation and User’s Guide • September 1999
4. Feed the stripped end of each wire into the appropriate hole in the DC input
connector.
FIGURE 3-7 shows which wires should be inserted into each hole in the DC input
connector.
FIGURE 3-7 Assembling the DC Input Power Cable
5. Repeat Step 3 and Step 4 for the other two wires to complete the assembly of the
DC input power cable.
6. If you are not using the optional strain relief housing, secure the wires together
with a wire tie.
7. Repeat Step 2 through Step 6 to wire the other five DC input power connectors.
Note that you will require a separate DC power source for each DC input.
If you need to remove a wire from the DC input connector, insert the cage clamp
operating lever or a small screwdriver into the slot directly above the wire to free the
wire from the cage clamp, and press down (
FIGURE 3-6).
▼ To Install the Optional Strain Relief Housings
1. Take the DC input connector and insert the bottom portion of the strain relief
housing into the notch on the DC input connector until it snaps into place.
Make sure the strain relief housing snaps into place on the DC input connector; you
will not be able to complete the assembly correctly if the strain relief housing is not
snapped into place.
Top of connector
from -48VDC / -60VDC Return
from ground
from -48VDC / -60VDC Supply
123
LW3User.book Page 18 Wednesday, November 10, 1999 9:00 AM