Operation Manual

Chapter 2 Installing the System 9
Optional Components
Select the mounting position most suitable for the rack type (see FIGURE 2-3). There
are four fixing locations provided on a Netra t 1400/1405; one at the front, two in the
centre and one at the rear. If the front location is required, first ensure that, if fitted,
the sacrificial shipping plates have been removed (see
FIGURE 2-2 on page 7). Where
possible, the four sacrificial shipping plates should only be removed after mounting
the system in a rack.
Fit the mounting flanges in the selected position using the four M5 countersunk
screws per flange provided with the mounting kit and a Phillips No. 1 screwdriver.
If required, you can fit the supplied handles to the mounting flanges before fitting
flanges to the system or, alternatively, fit them to the mounted flanges.
FIGURE 2-4 on page 10 shows how to connect the Flange Mount assembly to the
Netra t 1400/1405 system.
TABLE 2-1 Optional Mounting Flange Kits
Mounting Option Part Number
19-inch configuration X7071A
23-inch configuration X7072A
24-inch configuration X7073A
600-mm configuration X7074A
LW3User.book Page 9 Wednesday, November 10, 1999 9:00 AM