SunXtender Specifications

0619
2009 San Bernardino Road | West Covina, CA 91790
626.813.1234 626.813.1235
www.sunxtender.com
A Division of Concorde Battery Corp.
PVX-420T Specifications
Voltage 12 Volts
Industry Reference U1 Tall
Maximum Weight 30 LB / 13.6 KG
Nominal Capacity Ampere Hours @ 25° C (77° F) to 1.75 volts per cell
1 Hr. Rate 2 Hr. Rate 4 Hr. Rate 8 Hr. Rate 24 Hr. Rate 100 Hr. Rate
26 Ah 33 Ah 34 Ah 36 Ah 42 Ah 44 Ah
Specifications are subject to change without notice. The data/information
contained herein has been reviewed & approved for general release on
the basis that this document contains no export controlled information.
PVX-420T
PVX-420T
SOLAR BATTERY
8.05
(204.4 MM)
7.71
(195.9 MM)
7.51
(190.8 MM)
2 M6 TERMINALS
7.34
(186.5 MM)
7.85
(199.3 MM)
5.18
(131.6 MM)
4.96
(126.0 MM)
SOLAR BATTERY
M6 Threaded Insert Standard
Terminals (Copper Alloy)
M6 Threaded Inserts are used for PVX-
340T & PVX-420T only. All batteries
with a “T” at the end of the part
number incorporate M8 threaded insert
terminals, all batteries are supplied with
silicon bronze bolts, nuts, and washers
required for installation.
Sun Xtender pioneered renewable energy storage
batteries for Off Grid and Grid Tied Solar and Wind
Systems as well as back up power for essential appliances
and machines such as cash registers, computers, and
telephony. PVX-420T is a deep cycle battery with AGM
construction.
Since 1987, Sun Xtender Battery has been designing
valve regulated lead acid batteries with AGM
construction (VRLA-AGM). The non-spillable construction
eliminates the requirement to monitor and replenish
water levels.
Utilizing pure lead calcium grids, the plates are thicker
than the industry standard for longer cycle life, increased
reliability and power. The low impedance AGM design
allows for excellent charge acceptance and there is no
current limit required with controlled voltage charging.
The complete Sun Xtender product line features
proprietary PolyGuard
®
Microporous Polyethylene
Separators, shielding the positive plates against shorting,
shock or vibration. No other manufacturers offer this dual
layer insulation protection feature.
Sun Xtender battery covers and containers are uniquely
molded with high impact, reinforced copolymer
polypropylene and are designed with thick end walls
to prevent bulging. The copper alloy T Terminals are
corrosion resistant and are supplied with silicon bronze
bolts and washers.
All SunXtender Batteries ship Hazmat Exempt.