Installation Guide

10 Interior Finishing:

Run drywall (or other nishing material) up the inside

face of the skylight curb. Slip the drywall up until it

bumps against the ledge in the top of the curb.

In conditions where excessive condensation is a concern, painting or

staining is recommended for interior wood liner.

5 Shingle up roof to bottom of roof opening.

6 Apply a ½'‘ wide bead of caulking, set back 1" from the

roof opening around the entire opening. Set a second ½"

wide bead around the entire opening, set 1" back from

the rst bead. Sealant applied too close to the opening

may “ooze” into the opening. Can also use 3" wide x 18"

thick butyl tape, if compatible, set ½" back from opening.

7 Set skylight over opening. Screw into place through the

pre-drilled holes in the ange with the #8 x 1" phillips pan

head screws provided (See Fastener Schedule). Cover the

head of each screw with sealant.

8 Now shingle up sides and across top. Place shingles, as far

in as possible, but be careful not to nail through skylight

ange.

IMPORTANT:

Bottom ange of skylight

MUST go on top of shingles.

9 Bottom ange will still be exposed: we recommend

leaving it this way. If you decide to put a "false

shingle"over it, be careful not to nail through skylight

ange.