Installation Guide

1
2
3
4
5
Secure the top pole (A) to the bottom pole(B).
Slowly turn the crank clockwise taking up the slack of the
cord.
Press the button as shown to tilt the umbrella to the
perfect position.
To turn LED lights on, switch the ON/OFF button
located on the crank housing to the ON (I)
position.
CAUTION: The Umbrella ribs may compress during
shipping. Before opening the umbrella turn it upside
down and shake it gently to sperate ribs.
!
CAUTION: The LED lights do not turn off automatically.
Always turn the lights off when not in use.
!
CAUTION: If you continue to turn the crank counter-clock-
wise after the umbrells is closed, the umbrella will start to
open again it is possible to open the umbrella by turning
the crank in a counter-clockwise direction. However, the
umbrella will not stay open when the crank is turned in a
counter-clockwise direction. The locking mechanism that
keeps the umbrella open only works when the crank is
turned in a clockwise direction
!
Hold this section
while adjusting
umbrella tilt.
Tilt Button
(See Illustration) Position battery compartment (A) at top
of umbrella (B).
Insert connector plug attached to umbrella into receptacle
located on battery compartment.
Insert battery compartment stem into top of umbrella.
Turn battery compartment clockwise to lock and secure.
Solar Panel receives charge from sunlight.
B
A
Mounting
Stem
Connector
Plug
B
C
Crank
Handle
ON/OFF
Switch