Manual

Carefully read the safety guidelines before installing the device.
At the end of the installation, make sure no other objects are
inside the CM MP or deposited on the electronic board. Tighten
all 4 screws with the washers on the cover before powering up
the device. Failure to properly ground the controller may result
in electric shock or even death.
4. CM MP use and programming
4.1 Initial Views
Inv: ON/OFF Mot: ON/OFF
p = XX.X [bar]
P is the pressure value read by the pressure transducer.
Inv: ON/OFF Mot: ON/OFF
V_in = XXX [V]
V_in is the line voltage.
Inv: ON/OFF Mot: ON/OFF
I_in = XX.X [V]
I_in is the line current.
Inv: ON/OFF Mot: ON/OFF
cosphi = X.XX
cosphi index means the angle phi between the voltage and current
absorbed by the pump.
Inv: ON/OFF Mot: ON/OFF
P = XXXXX [W]
P is the power absorbed from the line.
Inv: ON/OFF Mot: ON/OFF
STATUS: NORMAL
Normal status means no alarms.
If an alarm occurs, a message blinks on the display and an audible
signal is activated.
Pressing ENTER ACCESSES: Inverter lifetime, pump lifetime,
consumption statistic, alarm list.
To return to previous views, press ENTER.
Inverter Life
xxxxx h : xx m
Motor Life
xxxxx h : xx m
STOP pump
Menu exi t
Alarms reset
START pump
ENTER
Scroll up
Scroll down
7