Server Module Installation Guide
Table Of Contents
- Sun Blade™ X6450 Server Module Installation Guide
- Contents
- Preface
- Introduction
- Installing and Configuring the Server Module
- Installation Worksheet
- Using the BIOS Configuration Utility to Configure the Sun Blade RAID 5 Expansion Module
- Introduction to the BIOS RAID Configuration Utility
- Understanding Hot-Plug Limitations and Conditions Within the BIOS RAID Configuration Utility
- Running the BIOS RAID Configuration Utility
- Using the ACU to Create and Manage Arrays
- Using the -Select Utility to Modify REM Settings
- Using the Disk Utilities to Manage Disk Drives
- Initializing a RAID Array
- Index
iv Sun Blade X6450 Server Module Installation Guide • September 2008
GRUB 12
Windows Bootloader 12
Accessing BIOS Configuration Utilities and Selecting a Boot Device 13
▼ To Configure Netboot or Compact Flash Boot in the BIOS 14
▼ To Configure the QLogic Fibre Channel in the BIOS 14
▼ To Configure the Emulex Fibre Channel PCIe ExpressModule in the
BIOS 14
▼ To Load an OS Over the Network (Netboot) 15
RAID Configuration 15
▼ To Configure the Sun Blade RAID 5 Expansion Module 16
▼ To Configure the Sun Blade 0/1 RAID Expansion Module 16
Installing an Operating System 17
Directing Console Output 17
2. Installing and Configuring the Server Module 19
Inserting the Server Module 19
▼ To Insert the Server Module 19
LED Behavior 21
Accessing and Configuring the ILOM 22
Displaying the Service Processor’s (ILOM) IP Address 23
▼ To Display the Service Processor’s (ILOM) IP Address 23
Connecting to the ILOM 23
▼ To Connect to the ILOM Web GUI 24
▼ To Connect to the ILOM CLI 25
Accessing and Configuring the ELOM 26
Displaying the Service Processor’s (ELOM) IP Address 27
▼ To Display the Service Processor’s (ELOM) IP Address 27
Connecting to the ELOM 28
▼ To Connect to the ELOM Web GUI 28