Server Module Installation Guide
Table Of Contents
- Sun Blade™ X6450 Server Module Installation Guide
- Contents
- Preface
- Introduction
- Installing and Configuring the Server Module
- Installation Worksheet
- Using the BIOS Configuration Utility to Configure the Sun Blade RAID 5 Expansion Module
- Introduction to the BIOS RAID Configuration Utility
- Understanding Hot-Plug Limitations and Conditions Within the BIOS RAID Configuration Utility
- Running the BIOS RAID Configuration Utility
- Using the ACU to Create and Manage Arrays
- Using the -Select Utility to Modify REM Settings
- Using the Disk Utilities to Manage Disk Drives
- Initializing a RAID Array
- Index
Chapter 2 Installing and Configuring the Server Module 25
Note – After you log in to ILOM using the default user name and password, you
should change the the ILOM root account password (changeme). See the Sun
Integrated Lights Out Manager 2.0 User’s Guide for details.
3. Click Log In.
The web interface Versions page appears.
FIGURE 2-3 Versions Page
▼ To Connect to the ILOM CLI
You can access the ILOM CLI remotely through a Secure Shell (SSH) or serial
connection. Secure Shell connections are enabled by default.
If you do not know the ILOM’s IP address, find it as described in “Displaying the
Service Processor’s (ILOM) IP Address” on page 23.
The following procedure shows an example using an SSH client on a UNIX system.
Use an appropriate SSH client for your operating system. The default user name is
root and default password is changeme.
Follow these steps to log in to ILOM using the default enabled SSH connection:
1. To log on to the ILOM, type:
$ ssh root@ipaddress
where ipaddress is the ILOM IP address.
2. Type the password when prompted. The default is changeme:
Password: changeme