Server Module Installation Guide
Table Of Contents
- Sun Blade™ X6450 Server Module Installation Guide
- Contents
- Preface
- Introduction
- Installing and Configuring the Server Module
- Installation Worksheet
- Using the BIOS Configuration Utility to Configure the Sun Blade RAID 5 Expansion Module
- Introduction to the BIOS RAID Configuration Utility
- Understanding Hot-Plug Limitations and Conditions Within the BIOS RAID Configuration Utility
- Running the BIOS RAID Configuration Utility
- Using the ACU to Create and Manage Arrays
- Using the -Select Utility to Modify REM Settings
- Using the Disk Utilities to Manage Disk Drives
- Initializing a RAID Array
- Index
24 Sun Blade X6450 Server Module Installation Guide • September 2008
▼ To Connect to the ILOM Web GUI
Note – To improve response times, disable the browser proxy server (if used).
If you do not know the ILOM’s IP address, find it as described in “Displaying the
Service Processor’s (ILOM) IP Address” on page 23 .
Follow these steps to log in to the ILOM web interface:
1. To log in to the web interface, type the IP address of ILOM into your web
browser.
The web interface Login page appears.
FIGURE 2-2 Login Page
2. Type your user name and password.
You can use the default user name and password.
■ Default user name – root
■ Default password – changeme
The default user name and password are lowercase characters.
The default user is root, and the default password is changeme.