Server Module Installation Guide
Table Of Contents
- Sun Blade™ X6450 Server Module Installation Guide
- Contents
- Preface
- Introduction
- Installing and Configuring the Server Module
- Installation Worksheet
- Using the BIOS Configuration Utility to Configure the Sun Blade RAID 5 Expansion Module
- Introduction to the BIOS RAID Configuration Utility
- Understanding Hot-Plug Limitations and Conditions Within the BIOS RAID Configuration Utility
- Running the BIOS RAID Configuration Utility
- Using the ACU to Create and Manage Arrays
- Using the -Select Utility to Modify REM Settings
- Using the Disk Utilities to Manage Disk Drives
- Initializing a RAID Array
- Index
Chapter 2 Installing and Configuring the Server Module 23
Displaying the Service Processor’s (ILOM) IP
Address
Use the following procedure to display the ILOM’s network configuration, including
including the IP address of the ILOM SP, using the CMM ILOM.
This procedure also verifies that the ILOM is working correctly and that you can
access it through the CMM ILOM.
▼ To Display the Service Processor’s (ILOM) IP Address
1. Log in to the CMM ILOM CLI.
2. Type the command:
show /CH/BLn/SP/network
where n is the server module number or chassis slot ID.
The CMM ILOM displays information about the server module, including its IP
address and MAC address. For example:
Connecting to the ILOM
This section describes how to connect to the ILOM’s CLI and web GUI.
-> show /CH/BL0/SP/network
/CH/BL0/SP/network
Targets:
Properties:
type = Network Configuration
commitpending = (Cannot show property)
ipaddress = IPaddress
ipdiscovery = dhcp
ipgateway = IPgateway
ipnetmask = 255.255.252.0
macaddress = Macaddress
pendingipaddress = IPaddress
pendingipdiscovery = dhcp
pendingipgateway = IPgateway
pendingipnetmask = 255.255.252.0
Commands:
cd
set
show
->