Server Module Installation Guide
Table Of Contents
- Sun Blade™ X6450 Server Module Installation Guide
- Contents
- Preface
- Introduction
- Installing and Configuring the Server Module
- Installation Worksheet
- Using the BIOS Configuration Utility to Configure the Sun Blade RAID 5 Expansion Module
- Introduction to the BIOS RAID Configuration Utility
- Understanding Hot-Plug Limitations and Conditions Within the BIOS RAID Configuration Utility
- Running the BIOS RAID Configuration Utility
- Using the ACU to Create and Manage Arrays
- Using the -Select Utility to Modify REM Settings
- Using the Disk Utilities to Manage Disk Drives
- Initializing a RAID Array
- Index
20 Sun Blade X6450 Server Module Installation Guide • September 2008
2. Remove the filler panel.
Pull the lever out and eject the filler panel.
Do not discard the filler panel.
Caution – Do not operate the system with empty slots. Always insert a filler panel
into an empty slot to reduce the possibility of module shutdown.
3. Position the server module vertically so that the ejectors are on the right.
The following illustrations show the server module being inserted into the Sun
Blade 6000 modular system; your chassis might differ. See box 1 in
FIGURE 2-1 [1].
Caution – The server module is heavy. Use two hands to insert it into, or remove it
from, the chassis. If you remove a server module from the chassis, be prepared to
support the weight when it clears the chassis.