Server Module Installation Guide
Table Of Contents
- Sun Blade™ X6450 Server Module Installation Guide
- Contents
- Preface
- Introduction
- Installing and Configuring the Server Module
- Installation Worksheet
- Using the BIOS Configuration Utility to Configure the Sun Blade RAID 5 Expansion Module
- Introduction to the BIOS RAID Configuration Utility
- Understanding Hot-Plug Limitations and Conditions Within the BIOS RAID Configuration Utility
- Running the BIOS RAID Configuration Utility
- Using the ACU to Create and Manage Arrays
- Using the -Select Utility to Modify REM Settings
- Using the Disk Utilities to Manage Disk Drives
- Initializing a RAID Array
- Index
19
CHAPTER
2
Installing and Configuring the
Server Module
This chapter provides instructions for installing and configuring the server module.
It contains the following sections:
■ “Inserting the Server Module” on page 19
■ “Accessing and Configuring the ILOM” on page 22
■ “Accessing and Configuring the ELOM” on page 26
■ “Configuring the Service Processor’s Network Settings (Optional)” on page 30
■ “Accessing the System Console” on page 31
■ “Dongle Cable Connections” on page 38
Inserting the Server Module
Caution – Before handling components, attach an electrostatic discharge (ESD)
wrist strap to bare metal on the chassis. Both the front and back of the chassis have
grounded locations. The system’s printed circuit boards contain components that are
extremely sensitive to static electricity.
▼ To Insert the Server Module
1. Locate the desired slot in the chassis.