Network Card User Manual

28 SunATM 3U CompactPCI Adapter Installation and User’s Guide • February 2001
atmadmin Parameter Groups
The atmadmin configuration program contains a series of menus where you can
input or alter the configuration of specific SunATM software parameters.
TABLE 4-2 summarizes the configurable parameters in each parameter group.
Although the parameter list appears lengthy, you need only the default values for
most standard configurations. The large number of parameters offer the flexibility to
support special-case configurations and to allow interoperability with equipment
from other vendors.
Note – In most cases, you need to configure only the parameters that do not have
default values.
TABLE 4-2 Configurable Parameters in the SunATM Software
Group Parameters Possible Values Default Values Required?
System SNMP agent status agent or not_agent not_agent Yes
SNMP agent UDP
port
0<= n <= 65355 1000 For SNMP
agent
Physical layer Framing interface SONET or SDH SONET Yes
Signalling UNI version 3.0, 3.1, 4.0, or none No default Yes
ILMI ILMI status Enabled or Disabled Enabled Yes
Classical IP Hostname/IP address Valid hostname and
IP address
No default For Classical IP
Interface Type Client, server, or
Standalone
No default For Classical IP
Local ATM address Valid ATM address $myaddress For Classical IP
clients or
servers
ARP server Valid ATM address $localswitch_se
rver
For Classical IP
clients
PVC 32 <= n < 1024 32 For Classical IP
standalones
Destination hostname
or IP address
Valid hostname and
IP address
No default For Classical IP
standalones
LAN emulation Instance number 0 <= n <= 999 No default For LAN
emulation