Whiteboard Accessories User Manual
164 Sun Crypto Accelerator 4000 Board Installation and User’s Guide • May 2003
▼ To Zeroize the Sun Crypto Accelerator 4000
Board With the Hardware Jumper
1. Power off the system.
Note – For some systems, you can use dynamic reconfiguration (DR) to remove and
replace the board as necessary for this procedure instead of powering off the system.
Refer to the documentation delivered with your system for the correct DR
procedures.
Caution – The board must not receive any electrical power while adjusting the
jumper.
2. Remove the computer cover to get access to the jumper located at the top middle
of the board.
3. Place the jumper on pins 0 and 1 of the jumper block.
Pins 0 and 1 are the pins closest to the bracket and labeled with a “Z.” There are four
sets of two pins and the jumper should only be placed on the 0 and 1 pin set as
shown in
FIGURE F-1.
Caution – You cannot use the Sun Crypto Accelerator 4000 board with the jumper
on pins 0 and 1.
FIGURE F-1 Sun Crypto Accelerator 4000 Board Jumper Block Pins
0246
1357