Whiteboard Accessories User Manual
Chapter 7 Diagnostics and Troubleshooting 121
Using the patchadd command to install patch 113614-11 is the equivalent of
replacing the previously installed SunVTS packages with the SunVTS5.1ps2
packages.
The replacement packages are available at:
http://www.sun.com/oem/products/vts/
The overlay patches are available at:
http://sunsolve.sun.com/
Note – The required SunVTS packages and any required patches must be installed
before the SUNWvcav package is installed. The SUNWvcav package contains the
SunVTS test vcatest.
Using SunVTS Software to Perform vcatest,
nettest, and netlbtest
Refer to the SunVTS test reference manual, user’s guide, and quick reference card for
instructions on how to perform and monitor these diagnostics tests. These
documents are available on the Solaris on Sun Hardware Documentation Set at
http://docs.sun.com. These documents are also provided on the Solaris
Software Supplement CD that is distributed with the Solaris release on your system.
Note – SunVTS can be used only if you have installed the required SunVTS
packages and any required SunVTS patches.
▼ To Perform vcatest
1. As superuser, start SunVTS.
Refer to the SunVTS user’s guide for detailed instructions on starting SunVTS.
The following instructions assume that you have started SunVTS using the CDE user
interface.
2. On the SunVTS Diagnostic main window, set the System Map to Logical mode.
# /opt/SUNWvts/bin/sunvts