Whiteboard Accessories User Manual
Chapter 5 Configuring Sun ONE Server Software for Use With the Sun Crypto Accelerator 4000 Board 89
Configuring Sun ONE Web Servers
This section describes the following:
■ “Passwords” on page 89
■ “Populating a Keystore” on page 90
■ “Overview for Enabling Sun ONE Web Servers” on page 91
■ “Installing and Configuring Sun ONE Web Server 4.1” on page 92
■ “Configuring Sun ONE Web Server 4.1 for SSL” on page 99
■ “Installing and Configuring Sun ONE Web Server 6.0” on page 101
■ “Configuring Sun ONE Web Server 6.0 for SSL” on page 108
Passwords
You are asked for several passwords in the course of enabling a Sun ONE Web
Server.
TABLE 5-1 provides a description of each. These passwords are referred to
throughout this chapter. If there is any confusion about which password to use, refer
to
TABLE 5-1.
TABLE 5-1 Passwords Required for Sun ONE Web Servers
Type of Password Description
Sun ONE Web Server
Administration
Server
Required to start up the Sun ONE Web Server Administration
Server. This password was assigned during the Sun ONE Web
Server setup.
Web Server Trust
Database
Required to start the internal cryptographic module when running
in secure mode. This password was assigned when creating a trust
database through the Sun ONE Web Server Administration Server.
This password is also required when requesting and installing
certificates into the internal cryptographic module.
Security Officer Required when performing vcaadm privileged operations.
username:password Required to start the Sun Crypto Accelerator 4000 module when
running in secure mode. This password is also required when
requesting and installing certificates into the internal cryptographic
module (keystore_name). This password consists of the username and
password of a keystore user that was created in vcaadm. The
keystore username and password are separated by a colon (:).