Computer Hardware User Manual

TABLE 12 Connectivity Map - HL7 MSH Segment (Continued)
Name Description
Validate MSH An indicator of whether to validate the MSH segment of the data message (for
inbound) and the MSH segment of the ACK (for outbound). Select true if you
want the Collaboration to validate the MSH segment; otherwise select false.
This parameter is used in Collaboration code.
Note – This property does not aect structural validation of the entire HL7
message itself. Structural validation is always performed.
HL7 SFT Segment — TCP/IP HL7 V2 Inbound Adapter
The following table lists and describes the properties that appear on the HL7 SFT Segment page
of the Properties Editor accessed from the Connectivity Map. These properties dene the
conguration of the SFT segment of the HL7 message, which provides additional information
about one or more software products used as sending applications. The primary purpose of this
segment is for diagnostic use. There may be additional uses per site-specic agreements. For
more information about this segment, refer to the HL7 specication (
http://www.hl7.org).
Note – The SFT segment is available starting with HL7 version 2.5.
TABLE 13 Connectivity Map - HL7 SFT Segment
Name Description
Enable An indicator of whether the SFT optional segment is enabled in the ACK. Select
true to enable the segment; otherwise select false.
Note – If Enable is set to true, and the HL7 version is not congured as 2.5, the
adapter will error upon startup.
Software Vendor
Organization
The name of the company that publishes or distributes the sending software that
created the transaction. This eld identies the vendor responsible for
maintaining the application. The purpose of this eld, along with the remaining
elds in this segment, is to provide a more complete prole of the sending
applications.
This is the rst eld in the HL7 SFT segment (SFT-01).
TCP/IP HL7V2 Adapter Inbound Connectivity Map Properties
Sun Adapter for TCP/IP HL7 User's Guide • October 200944