User's Manual

16 Sun StorageTek 4 Gb FC NEM 20-Port Host Bus Adapter User’s Guide • February 2008
4. Verify that the selected NEM has returned the expected feedback.
See “To Verify NEM Status” on page 17.
Using the ILOM Command-Line Interface
1. Log in to the ILOM CLI of the active Chassis Monitoring Module.
2. For a list of components in your system, type:
show /CH
3. If you installed a new NEM, go to Step 4.
When you were preparing a NEM for a hot-remove, if you corrected the problem
without removing the NEM or you decided not to remove the NEM, complete
the following steps:
a. Type this command to prepare a component for a hot-insert:
set /CH/component return_to_service_action=true
For example:
set /CH/NEM1 return_to_service_action=true
b. Use the show /CH/component command to list the status of the connection
from the NEM to each of the blades.
Note – The following example depicts only the link status portion of the show
/CH/component command output.
-> show /CH/NEM1
blade0_link_status = Not_connected
blade1_link_status = Not_connected
blade2_link_status = Not_connected
blade3_link_status = Not_connected
blade4_link_status = Not_connected
blade5_link_status = Not_connected
blade6_link_status = Connected
blade7_link_status = Not_connected
blade8_link_status = Not_connected
fault_state = OK
clear_fault_action = (none)
prepare_to_remove_status = NotReady