User Guide

TABLE 1 SIA State File Variables (Continued)
Variable Description (Defaults in Bold)
Required for
Linux Install
Required
for
Firmware
Upgrade
apit.remoteUpdateURL If you specied “true” for remoteUpdate, tells SIA
where to look for SIA software updates. Values
supported: Any URL with updated SIA content les.
You only need to specify this variable if you are not
using the default url.
Default url:
http://sia-updates.sun.com/remoteUpdate
X (if
remote
Update is
true and
default url
is not
used)
X (if
remote
Update
is true
and
default
url is not
used)
apit.networking Tells SIA it has permission to work over the network.
If true, SIA will congure network settings based on
networkcong variables. Values supported: true |
false
Example: apit.networking=true
XX
apit.networkcong.needNetwork If you specied “true” for network, tells SIA whether
network access is required for a particular task.
Values supported: true | false
Example: apit.networkcong.needNetwork=true
X (if
networking
is true)
X (if
networking
is true)
apit.networkcong.activeNic If you specied “true” for network, tells SIA which
network interface is connected to the active network.
Values supported: eth0 | eth1 | eth2 | eth3 ... etc.
Example: apit.networkcong.activeNic=eth0
X (if
networking
is true)
X (if
networking
is true)
apit.networkcong.NetworkType If you specied “true” for network, tells SIA the
conguration of the active network interface. Values
supported: static | dhcp
Example: apit.networkcong.NetworkType=dhcp
X (if
networking
is true)
X (if
networking
is true)
apit.networkcong.useDHCP If you selected “dhcp” as the NetworkType, tells SIA
to obtain the server’s address from the DHCP server.
Values supported: true | false
Example: apit.networkcong.useDHCP=true
X (if
networking
is true)
X (if
networking
is true)
apit.networkcong.ipeld If you selected “static” as the NetworkType, tells SIA
to use the server’s IP address value you provide.
Example: apit.networkcong.ipeld=n.n.n.n
X (if static
IP is used)
X (if
static IP
is used)
apit.networkcong.gatewayField If you selected “static” as the NetworkType, tells SIA
to use the IP address value you provide.
Example: apit.networkcong.gatewayeld=n.n.n.n
X (if static
IP is used)
X (if
static IP
is used)
Contents of the SIA State File
45