Network Card User Manual

82 Sun Quad FastEthernet 6U CompactPCI Adapter Installation and User’s Guide • June 2000
4. Set the diag-switch? parameter to true to see the diagnostic power-on self-test
(POST) messages.
5. Reset the system to activate these parameter changes.
6. Use the show-nets command to display the list of network devices on the
system.
Among the list of devices, you should see the four SUNW,qfe devices specific to the
Sun Quad FastEthernet 6U CompactPCI adapter you want to test, as shown in the
following example.
Note – The preceding device paths are examples. The actual device paths on your
system may be different from the examples shown here.
7. Use the test command, and the device paths found in Step 6, to test the adapter
when you use the FCode self-test.
Refer to the appropriate OpenBoot Command Reference Manual for more information
on the test command.
ok setenv diag-switch? true
ok reset-all
ok show-nets
a) /pci@1f,0/pci@1/pci@1/pci@e/SUNW,hme@0,1
b) /pci@1f,0/pci@1/pci@1/pci@d/SUNW,qfe@3,1
c) /pci@1f,0/pci@1/pci@1/pci@d/SUNW,qfe@2,1
d) /pci@1f,0/pci@1/pci@1/pci@d/SUNW,qfe@1,1
e) /pci@1f,0/pci@1/pci@1/pci@d/SUNW,qfe@0,1
f) /pci@1f,0/pci@1/pci@1/pci@b/SUNW,hme@0,1
g) /pci@1f,0/pci@1/pci@1/pci@a/SUNW,hme@0,1
h) /pci@1f,0/pci@1,1/network@3,1
i) /pci@1f,0/pci@1,1/network@1,1
q) NO SELECTION
Enter Selection, q to quit: q
ok test device_path