Server User Manual
Table Of Contents
- Sun Netra™ CP3250 Blade Server User’s Guide
- Contents
- Figures
- Tables
- Preface
- Overview
- Hardware Installation and Service
- 2.1 Safety and Tool Requirements
- 2.2 Installing the Blade Server
- 2.3 Service Procedures
- 2.3.1 Hot-Swapping the Netra CP3250 Blade Server
- 2.3.2 Powering Off the Netra CP3250 Blade Server
- 2.3.3 Removing the Netra CP3250 Blade Server
- 2.3.4 Powering On the System
- 2.3.5 Automatic Power-Off Events
- 2.3.6 Servicing DIMMs
- 2.3.7 Installing the Optional Compact Flash Card
- 2.3.8 Installing Optional AMC
- 2.3.9 Adding or Replacing the Battery
- 2.3.10 Changing Jumper Settings
- 2.3.11 Checking DIP Switch Settings
- 2.3.12 Resetting the Netra CP3250 Blade Server
- Hardware Architecture
- Software Configuration
- Configuring and Using BIOS Firmware
- 5.1 About BIOS Settings
- 5.2 Changing the Configuration of a BIOS Menu Item
- 5.3 Setting the Boot Device Using BIOS Setup Screens
- 5.4 Setting Supervisor and User Passwords
- 5.5 Resetting the System Time and System Date
- 5.6 Updating the BIOS
- 5.7 Secondary BIOS Image
- 5.8 Perform a Live Firmware Upgrade
- 5.9 Power-On Self-Test
- 5.10 Changing POST Options
- BIOS Screens
- Physical Characteristics
- ShMM CLI and Commands
- Index
Index-1
Index
A
AMC cards supported, 1-8
AMC connectors, B-5
AMC devices
additional I/O, 1-8
installing, 2-27
B
barcode labels, locating, 1-13
BIOS
about settings, 5-2
changing boot device, 5-4
changing configuration, 5-3
changing passwords, 5-5
screen descriptions, 5-3
updating, 5-6
BIOS menus
Advanced Settings, A-3
Boot Setting, A-12
Boot Settings Configuration, A-13
CPU Configuration, A-4
IDE Configuration, A-5
PCI Express Configuration, A-10
Remote Access Configuration, A-9
Security Settings, A-14
Boot Setting menu, A-12
Boot Settings Configuration menu, A-13
booting, 1-7
C
cabling, 2-14
installing, 2-13
system console, 2-15
system console for Solaris, 2-13
chassis. See shelf, 1-7
CMOS settings
clearing, 2-31
collecting network information, 2-5
Compact Flash
installing, 2-24
configurations, I/O, 1-10
connectors, B-2
contacting support, 1-13
CPU Configuration menu, A-4
D
data transport connector, B-8
DDR-2 DIMM. See DIMMs, 2-19
DIMMs
described, 2-19
installing, 2-21
matching pairs, 2-19
removing, 2-23
E
electric shock caution, 2-2
Ethernet, RJ-45, B-3
F
front panel, B-5
H
hardware installation, 2-1 to 2-30