FastEthernet PCI Adapter Installation & User's Guide

3. Create an appropriate entry in the /etc/hosts ﬁle for each active qfe channel.

Using the example in Step 1 on page 11, you will have:

# cat /etc/hosts

# Internet host table

127.0.0.1 localhost

129.144.10.57 zardoz loghost

129.144.11.83 zardoz-11

129.144.12.41 zardoz-12

129.144.13.67 zardoz-13

129.144.14.30 zardoz-14

4. Reboot your system.

Booting From the Network

To use a Sun Quad FastEthernet PCI adapter ethernet interface as the boot device,

perform the following tasks:

1. At the ok prompt type:

ok show-devs

The show-devs command lists the system devices. You should see the full path

name of the qfe devices, similar to the example below:

/pci@1f,2000/pci@2/SUNW,qfe@0,1

/pci@1f,2000/pci@2/SUNW,qfe@1,1

/pci@1f,2000/pci@2/SUNW,qfe@2,1

/pci@1f,2000/pci@2/SUNW,qfe@3,1

Note - You need to select only one of these qfe devices for booting.

2. At the ok prompt type:

ok boot (full path name of the

qfe device)

Conﬁguring the Driver Software 13