User manual

Connecting up02

Easy connections

This is a basic setup that allows you to watch discs on your TV using

just the cables supplied.

Important

• This player is equipped with copy protection technology. Do not

connect this player to your TV via a VCR using AV cables, as the

picture from this player will not appear properly on your TV. (This

player may also not be compatible with some combination TV/

VCRs for the same reason; refer to the manufacturer for more

information.)

• Do not unplug the player from the power outlet while it is

switched on.

• Do not plug this player into a switched power supply found on

some amplifiers and AV receivers.

1 Connect the VIDEO OUT and one pair of AUDIO OUT jacks

to a set of audio/video inputs on your TV.

Use the supplied red/white stereo audio and yellow video cables.

Make sure you match up the left and right audio outputs with their

corresponding inputs for correct stereo sound.

See Using other types of video output below if you want to use a

different type of connection.

2 Connect the supplied AC power cord to the AC IN inlet,

then plug into a power outlet.

Using other types of video output

This player has standard (composite), S-Video and component video

outputs, as well as an HDMI connector (for digital video/audio).

In order to be able to watch HD (high definition) BDs at their full

resolution, you should connect the player to your TV using either the

component video output, or (even better) the HDMI output.

An HDMI connection will additionally give you HD output when

watching DVDs.

If your display has neither of these connection types, an S-Video jack

is also provided, which should give slightly better video quality than

using the standard video output.