Replacement Part List

10
Maintenance
mWARNING! Always switch the product o, and let the
product cool down before performing inspection, maintenance
and cleaning work! Maintain this product regularly and
carefully! If the product is not maintained properly, it may fail at
its intended task, which may produce fatal consequences.
mWARNING! Only perform repairs and maintenance
work according to these instructions! All further works must be
performed by a qualied specialist!
mWARNING! Always wear protective gloves during
maintenance tasks. Do not carry out maintenance when the
motor is running or hot.
• Never use water or chemical cleaners to clean your grass
trimmer. Wipe it clean with a dry cloth.
• Plastic parts may be cleaned by using mild soap and a
damp rag.
• Always store your trimmer in a dry place. Do not allow any
liquid to get inside it.
• Your trimming line can dry out over time. To keep your line
in top condition, store spare pre-wound spools or bulk line
in a plastic resealable bag with a tablespoon of water.
IMPORTANT! To ensure product safety and reliability, repairs,
maintenance, and adjustments to this power tool should be
performed only with identical replacement parts. Contact your
authorized Snow Joe
®
+ Sun Joe
®
dealer or call the Snow Joe
®
+ Sun Joe
®
customer service center at 1-866-SNOWJOE
(1-866-766-9563) for assistance.
Replacing the Spool + Clearing Jams
and Tangled Lines
mWARNING! Unplug the extension cord from the mains
power plug before changing the trimming line.
1. Press together both release tabs on the line spool cover
to remove the cover and the spool by pulling them straight
o (Fig. 15 – 16).
2. Remove any broken trimming line, wind the remaining line
tight and re-insert the spool into the spool cover as follow,
or insert a new pre-wounded spool.
3. To use a new spool, rst unhook the end of the cutting
line from the spool, and insert the end of the cutting line
through the eyelet on the machine (Fig. 17).
4. Insert the spool inside the machine, press hard until it
clicks in place. Adjust the length of the trimming line
outside by pulling the trimming line to lengthen, or rotating
the spool counter-clockwise to shorten. Replace the spool
cover, make it sit securely to lock the assembly (Fig. 18).
IMPORTANT: Only use original replacement parts specied for
this machine.
Fig. 15
Spool cover
Spool cover
releasing
tab
Fig. 16
Spool cover
Spool
Fig. 17
Spool
Insert the end
of trimming line
through the eyelet
Fig. 18
Spool cover