Full Product Manual

Changing the Tines

NOTE: The tines in the motor housing are provided by the

manufacturer. Only use tines that have been supplied by the

manufacturer. Ensure the tines are in good condition prior to

operation.

To replace the tines, using the following procedure:

1. Turn OFF the cultivator and unplug the power cord.

2. Place the unit on a at surface and stand in a safe

position.

3. Remove the locknut with a socket wrench and

disassemble the blades (Fig. 5).

4. Remove the old blades while taking note of the sequence

of assembly. Install the new blades in the order they were

prior to disassembly. Tighten with the locknut.

(Figs. 6 – 11).

IMPORTANT:

The tines must be set in the correct turning

direction. Note the position of the original tines, and replace

them in the exact same direction.

5. Only use tines that are produced by the manufacturer.

Fig. 5

Blade

Fig. 6

Fig. 7

Fig. 8

Fig. 9

Fig. 10

Fig. 11