Replacement Part List

3. Remove the old chain from the bar.

NOTE: When you rst purchase your pole chain saw, the

chain and bar will come separately with the saw. Refer

only to the instructions for tting the chain and bar (start

with step 4). Should you need to replace the chain in the

future, follow all the steps in this section.

4. Lay out the new saw chain in a loop and straighten

any kinks. THE SHARP SIDE OF THE TEETH MUST

FACE AWAY FROM YOU IN THE DIRECTION OF THE

CHAIN ROTATION INDICATED ON THE GUIDE BAR

. If the teeth face backwards, turn

the loop over (Fig. 3).

5. Starting at the tip, mount the chain drive links into the

bar groove, leaving a loop at the back of the bar. The

chain will loosely t until it is placed on the sprocket

(Figs. 4 – 5).

NOTE: Make certain of the direction of the chain

.If the chain is mounted

backwards, the saw will vibrate abnormally and will not

cut.

6. Position the chain so there is a loop at the back of the bar.

Hold the chain in position on the bar and place the loop

around the sprocket (Fig. 6).

7. Fit the bar ush against the mounting surface so that the

bar slot mounts onto the slot ange in the head and hold

rmly in place (Fig. 6).

NOTE: When placing the bar on the ange, ensure that

the tensioner pin is in the chain tensioner pin hole in the

bar. Adjust the chain tension as needed by adjusting the

chain tensioner screw with the blade screwdriver so it

lines up with the pin hole in the bar (Fig. 7).

Fig. 3

Chain rotation

Sharp cutting edge

Chain drive link

Fig. 4

Fig. 5

Loop

Chain over sprocket

Fig. 6

Bar slot over

slot ange

Chain tensioner

pin in hole

Fig. 7